Repeating Vang Settings
Posted: Tue Nov 21, 2023 9:46 pm
What is a good way to mark the boom vang to repeat settings?
The J/109 Class Association Forum
J/109 Sailboat discussions with your one stop source for J/109 information. Where J/109 owners may buy and sell boats, equipment and sails. The forum is a separate registration and log in from the Class website.
https://j109.org/forum/
Repeating Vang Settings
Page 1 of 1
Re: Repeating Vang Settings
Posted: Wed Nov 22, 2023 2:07 am
I put an arrow on both sides of the block and taped zebra stripes on the cylinder with numbers. My vang is double ended and normally controlled from the cockpit. The end by the mast is for knockdowns only.
Re: Repeating Vang Settings
Posted: Wed Nov 22, 2023 4:25 pm
Thank you!
Re: Repeating Vang Settings
Posted: Thu Aug 28, 2025 9:33 am
I am curious, would you have a picture of how you made it double-ended?
My vang is squeeking, the manual says to put grease on the spring, with no specifics about how to get to it other than a parts diagram. Have you done this? What is involved? Is this difficult or time-consuming? Thank you for your insights always!
My vang is squeeking, the manual says to put grease on the spring, with no specifics about how to get to it other than a parts diagram. Have you done this? What is involved? Is this difficult or time-consuming? Thank you for your insights always!
Re: Repeating Vang Settings
Posted: Thu Aug 28, 2025 9:52 am
This is an old picture that shows the mast end for double ending. The lead aft goes through the deck organizer and uses the port inboard Spinlock clutch. You can follow the Harken Vang Manual diagram for disassembly and reassembly.
Improved with turning block at center
- double-ended-vang.jpg (906.49 KiB) Viewed 8657 times
- turning-block-vang-base (1).jpg (1.52 MiB) Viewed 8655 times